$295.00
Regular $315.00
|
The CEM24-Super telephone controlled thermostat has been
designed for homes, condos, rental properties, vacation homes,
boats, recreational vehicles, offices etc. By simply calling a
telephone number, you can find out the room temperature, and if any
fault condition exists, place the control in "economy or comfort"
mode.
When replacing a regular heat only mechanical thermostat with this
electronic thermostat, a third wire will be required to supply the 24 vac
common. When using this thermostat in a Heat/Cool system a fifth wire will
be required to supply the 24 vac common.
Note: We strongly advise that this thermostat be installed by a qualified HVAC
professional
Temperature Range: 40F / 90F (7C / 29C)
Accuracy: +/- 2F
Differential: Smart Sensing
Voltage: 24 VAC
Load Rating: 2 amps Relay Contacts
Stages: Up to 2 Heat 2 Cool; Heat pump compatible
Ambient Storage Temp: -20F to 135F
CEM24-Super |
All-in-one Heat/Cool or Heat Pump
|
|
CEO24 |
All-in-one Heat/Cool Thermostat with a built in Freeze Alarm. This unit has all the features of the CEM24 telephone controlled thermostat, but it also includes a freeze alarm. Please note that this unit can not be used with a heat pump.
Unit can call any 3 numbers to let user know if the temperature falls below a set threshold. |
|
RS01 |
Optional remote sensor in decorative box |
$22.00
|
TS01 |
Optional Remote sensor 30" lead |
$14.75
|
For a
free demonstration of how to access a CEM
thermostat call the following number:
1-877-662-0660
The PIN is 1234# For menu press * 0 # |
Quick Start Instructions
- Dial the phone at the thermostat location, after 4 rings you
will hear “hello it’s your thermostat, please enter
password.
- Press 1.2.3.4. then, the # key.
- Then the thermostat will say “Temperature in the room is xx
deg” ---“System is ON” or
- System is OFF” ---“Mode is now economy mode”---“Please
enter your desired command”
Commands
- Press * 1 # to turn System ON
- Press * 2 # to turn System OFF
- Press * 3 # to select cooling temperature e.g. 72 #
- Press * 4 # to select heating temperature e.g. 70 #
- Press * 5 # to select system mode:
- 1 # selects AUTO HEAT/COOL
- 2 # selects FAN only
- 3 # selects Cooling only
- 4 # selects Heat only
- Press * 6 # to select Program On/Off:
- 1 # Program On
- 2 # Program OFF
- Press * 7 # to select Turn Economy Mode On/Off:
- 1 # Economy Mode On
- 2 # Economy Mode OFF
- Press * O # for Command Mode:
- Press * 9 # after every session to save your changes, then
hang up to end the call.
|
|
